Why is river water treated as contaminated?
Flood water has crossed streets, yards and drains before it reached your building, and it carries silt and whatever it picked up. Restoration treats it as the dirtiest category, which means protective gear, disposal of soaked porous materials and cleaning of every surface it touched.
The distinction drives almost every decision on a flood job. Clean water from a supply pipe lets a crew dry materials in place and keep them. Water that came in off the ground does not, because the contamination is inside the material, not just on its face. Carpet pad, fibre insulation and particle board that have been in flood water do not come back.
It also sets the handling. Crews work in protective equipment, keep the dirty route separate from clean parts of the building, and clean down hard surfaces rather than just drying them. Households are asked to stay off that level until the cleaning is finished, which is a precaution rather than an alarm.
Does a cellar have to be pumped out slowly?
Yes, when the ground outside is still saturated or water is standing against the walls. Emptying a cellar faster than the surrounding ground drains removes the pressure holding an old foundation in balance. The crew lowers the level in stages and watches the walls.
Water pressing on both sides of a cellar wall cancels out. Take it away from the inside while it is still high on the outside and the wall carries the whole load, which an old stone or brick foundation with soft mortar may not be in a position to do. That is a real risk in buildings of the age found across these river towns.
So pumping on a river job is paced rather than rushed, usually in stages with time between them, and the walls and floor are watched for movement or new cracking as the level drops. It feels slow on the day and it is the right call.
What moves the price of a flood cleanup up or down?
How much of the building the water reached, how deep the silt is, how much material must be removed and disposed of, and how long dense masonry then takes to dry. Contaminated water costs more to handle than clean water. Everything is scoped and approved before work starts.
A flood job has three cost drivers that a clean-water job does not: removal and disposal of contaminated material, the cleaning step, and the handling of contents. The first depends on how much porous material the water reached, which is mostly a question of depth. The second depends on surface area. The third depends on what was stored on that level.
Then there is the building itself. Older masonry in these towns holds water, so drying days run long, and access on a narrow street or through a single stair adds set-up time. A property with several units multiplies all of it.
You will not find a figure anywhere on this site for this trade, by design. A technician walks the building, scopes the removal, the cleaning and the drying, explains what each is for, and begins once you have approved it.
Has the risk changed since those historic floods?
The National Weather Service office in Albany reports that flooding problems near Albany and south of it eased after dredging for shipping in the 1930s. That is a documented change in the river, not a promise about any particular storm, and low ground near the water still floods.
The record is worth reading honestly in both directions. The great floods on this stretch are from 1857, 1913 and 1936, and the Weather Service attributes a reduction in problems around and below Albany to the dredging of the shipping channel in the 1930s. An Albany Argus article, quoted on a local blog, described Troy and Green Island flooded in an ice, storm and thaw event in March 1919.
What has not changed is the ground. Level flood-plain land in the South End, and low riverside blocks in Green Island, Watervliet, Rensselaer and parts of Troy and Lansingburgh, are where water goes when there is a lot of it. That is why a river town building is planned around its lowest level.
What can be saved after a flood, and what should go?
Masonry, framing, solid wood, metal and most hard surfaces clean and dry. Carpet and pad, fibre insulation, chipboard furniture, mattresses, upholstery and soaked paper generally do not. Each item is photographed and listed before it leaves so you have a record.
The rule of thumb is porosity. A material that water and sediment can get inside cannot be cleaned to a standard anybody should live with, so it is removed. A material that holds water only in its surface or its pores can be washed, treated and dried. That is why a flooded cellar loses its stored boxes and keeps its stone walls.
Contents are handled with the same logic but more care, because the value is personal rather than structural. Items you want attempted are set aside and dried separately where there is any chance, and nothing is discarded without being listed and photographed first for insurance claim documentation.